Influence of mixture composition on thermal properties of concrete and the performance of rigid pavement

Parth Panchmatia; Michał A. Glinicki; Jan Olek

doi:10.7409/rabdim.014.016

Published: 2014-04-01

Vol. 13 No. 3 (2014)

Influence of mixture composition on thermal properties of concrete and the performance of rigid pavement

Parth Panchmatia , Michał A. Glinicki , Jan Olek

Section: Articles

https://doi.org/10.7409/rabdim.014.016

Abstract

The recent mechanistic-empirical pavement design guide (MEPDG) put more emphasis on the effects of thermal curling stresses on rigid pavement analysis and design. Mix design of concrete has significant influence on its thermal properties such as thermal conductivity, coefficient of thermal expansion, and specific heat. Aggregate type and content significantly alter the thermal properties of concrete incorporating them. The moisture state of the concrete increases its specific heat and thermal conductivity. A review of the effect of temperature of fresh concrete on early age properties is also presented. The performance of rigid pavements exposed to seasonal and daily fluctuations in temperature is discussed. Airfield concrete pavements which are subjected to jet engine exhausts experience heat cycles micro-cracking, coarsening of microstructure and loss of compressive and flexural strength. These effects are mostly the result of the dehydration and decomposition of paste matrix in concrete. Heat cycles result in concrete deterioration similar in appearance to freezing and thawing deterioration.

Keywords:

coefficient of thermal expansion, temperature gradient, thermal conductivity, thermal properties, concrete pavement

Most read articles by the same author(s)

Daria Jóźwiak-Niedźwiedzka, Karolina Gibas, Michał A. Glinicki, Petrographic identification of reactive minerals in domestic aggregates and their classification according to RILEM and ASTM recommendations , Roads and Bridges - Drogi i Mosty: Vol. 16 No. 3 (2017)
Daria Jóźwiak-Niedźwiedzka, Aneta Antolik, Kinga Dziedzic, Michał A. Glinicki, Karolina Gibas, Resistance of selected aggregates from igneous rocks to alkali-silica reaction: verification , Roads and Bridges - Drogi i Mosty: Vol. 18 No. 1 (2019)
Michał A. Glinicki, Daria Jóźwiak-Niedźwiedzka, Aneta Antolik, Kinga Dziedzic, Karolina Gibas, Susceptibility of selected aggregates from sedimentary rocks to alkali-aggregate reaction , Roads and Bridges - Drogi i Mosty: Vol. 18 No. 1 (2019)
Mariusz Dąbrowski, Michał A. Glinicki, Air void system parameters and frost resistance of air-entrained concrete containing calcareous fly ash , Roads and Bridges - Drogi i Mosty: Vol. 12 No. 1 (2013)
Grzegorz Knor, Michał A. Glinicki, Jan Holnicki-Szulc, Determination of thermal parameters of hardening concrete by means of inverse problem solution , Roads and Bridges - Drogi i Mosty: Vol. 11 No. 4 (2012)
Michał A. Glinicki, Evaluation and design of fibre reinforced concrete using the equivalent flexural strength , Roads and Bridges - Drogi i Mosty: Vol. 1 No. 3 (2002)
Michał A. Glinicki, Roman Jaskulski, Mariusz Dąbrowski, Design principles and testing of internal frost resistance of concrete for road structures - critical review , Roads and Bridges - Drogi i Mosty: Vol. 15 No. 1 (2016)
Michał A. Glinicki, Analysis of flexural strength of concrete specified for road pavement , Roads and Bridges - Drogi i Mosty: Vol. 4 No. 1 (2005)
Karolina Gibas, Michał A. Glinicki, Grzegorz Nowowiejski, Evaluation of impermeability of concrete containing calcareous fly ash in respect to environmental media , Roads and Bridges - Drogi i Mosty: Vol. 12 No. 2 (2013)
Wojciech Kubissa, Mariusz Dąbrowski, Bartłomiej Chojnacki, Michał A. Glinicki, Durability of paving concrete produced in a laboratory setting and obtained in field at expressway construction site , Roads and Bridges - Drogi i Mosty: Vol. 20 No. 4 (2021)

1 2 > >>

Download files

PDF

Citation rules

Panchmatia, P., Glinicki, M. A., & Olek, J. (2014). Influence of mixture composition on thermal properties of concrete and the performance of rigid pavement. Roads and Bridges - Drogi I Mosty, 13(3), 235–260. https://doi.org/10.7409/rabdim.014.016

Cited by / Share

References

AASHTO Guide for Design of Pavement Structures. American Association of State Highway and Transportation Officials, Washington, 1986
Google Scholar

Mechanistic-Empirical Pavement Design Guide – A Manual of Practice. American Association of State Highway and Transportation Officials, Washington, 2008
Google Scholar

ASTM C177-13 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate. ASTM International, West Conshohocken, 2013
Google Scholar

ASTM C1045-07 Standard Practice for Calculating Thermal Transmission Properties Under Steady-State Conditions. ASTM International, West Conshohocken, 2013
Google Scholar

ASTM C518-10 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus. ASTM International, West Conshohocken, 2010
Google Scholar

ASTM E1530-11 Standard Test Method for Evaluating the Resistance to Thermal Transmission of Materials by the Guarded Heat Flow Meter Technique. ASTM International, West Conshohocken, 2011
Google Scholar

ASTM E1952-11 Standard Test Method for Thermal Conductivity and Thermal Diffusivity by Modulated Temperature Differential Scanning Calorimetry. ASTM International, West Conshohocken, 2011
Google Scholar

AASHTO T336-11. Coefficient of Thermal Expansion of Hydraulic Cement Concrete. American Association of State Highway and Transportation Officials, Washington, 2011
Google Scholar

AASHTO TP60-00. Coefficient of Thermal Expansion of Hydraulic Cement Concrete. American Association of State Highway and Transportation Officials, Washington, 2000
Google Scholar

ASTM C531-00 Standard Test Method for Linear Shrinkage and Coefficient of Thermal Expansion of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes. ASTM International, West Conshohocken, 2000
Google Scholar

ASTM C490-11 Standard Practice for Use of Apparatus for the Determination of Length Change of Hardened Cement Paste, Mortar, and Concrete. ASTM International, West Conshohocken, 2011
Google Scholar

ASTM D4611-08 Standard Test Method for Specific Heat of Rock and Soil. ASTM International, West Conshohocken, 2008
Google Scholar

ASTM D2766-95 Standard Test Method for Specific Heat of Liquids and Solids. ASTM International, West Conshohocken, 1995
Google Scholar

Zhang Y., Sun W., Liu S.: Study on the hydration heat of binder paste in high-performance concrete. Cement and Concrete Research, 32, 9, 2002, 1483-1488
Google Scholar

Nocuń-Wczelik W.: Heat evolution in hydrated cementitious systems admixtured with fly ash. Journal of Thermal Analysis and Calorimetry, 65, 2, 2001, 613-619
Google Scholar

Knor G., Glinicki M.A., Holnicki-Szulc J.: Determination of thermal parameters of hardening concrete by means of inverse problem solution. Roads and Bridges - Drogi i Mosty, 11, 4, 2012, 281-294
Google Scholar

Knor G., Glinicki M.A., Holnicki-Szulc J., Ossowski A., Ranachowski Z.: Influence of calcareous fly ash on the temperature of concrete in massive elements during the first 72 hours of hardening. Roads and Bridges - Drogi i Mosty, 12, 1, 2013, 113-126
Google Scholar

U.S. Bureau of Reclamation, Concrete Manual, 8th edition, 1988
Google Scholar

Ghafoori N., Diawara H.: Influence of temperature on fresh performance of self-consolidating concrete. Construction and Building Materials, 24, 6, 2010, 946-955
Google Scholar

Neville A.M.: Properties of concrete. Fourth Edition John Wiley & Sons, Inc., New York, 1997
Google Scholar

Mackiewicz P.: Thermal stress analysis of jointed plane in concrete pavements. Applied Thermal Engineering, 73, 1, 2014, 1167-1174
Google Scholar

Siwińska A., Garbalińska H.: Thermal conductivity coefficient of cement based mortars as air relative humidity function. Heat and Mass Transfer, 47, 9, 2011, 1077-1087
Google Scholar

Kim K.H., Jeon S.E., Kim J.K., Yang S.: An experimental study on thermal conductivity of concrete. Cement and Concrete Research, 33, 3, 2003, 363-371
Google Scholar

Jerman M., Keppert M., Výborný J., Černý R.: Hygric, thermal and durability properties of autoclaved aerated concrete. Construction and Building Materials, 41, 1, 2013, 352-359
Google Scholar

Panesar D.K., Shindman B.: The mechanical, transport and thermal properties of mortar and concrete containing waste cork. Cement and Concrete Composites, 34, 9, 2012, 982-992
Google Scholar

Kim H.K., Jeon J.H., Lee H.K.: Workability, and mechanical, acoustic and thermal properties of lightweight aggregate concrete with a high volume of entrained air. Construction and Building Materials, 29, 2012, 193-200
Google Scholar

Khaliq W., Kodur V.: Thermal and mechanical properties of fiber reinforced high performance self-consolidating concrete at elevated temperatures. Cement and Concrete Research, 41, 11, 2011, 1112-1122
Google Scholar

Loser R., Münch B., Lura P.: A volumetric technique for measuring the coefficient of thermal expansion of hardening cement paste and mortar. Cement and Concrete Research, 40, 7, 2010, 1138-1147
Google Scholar

Sellevold E.J., Bjřntegaard Ř.: Coefficient of thermal expansion of cement paste and concrete: Mechanisms of moisture interaction. Materials and Structures, 39, 9, 2006, 809-815
Google Scholar

Rajabipour F., Weiss J.: Electrical conductivity of drying cement paste. Materials and Structures, 40, 10, 2006, 1143-1160
Google Scholar

Bjontegard O., Sellevold E.J.: Interaction between thermal dilation and autogenous deformation in high performance concrete. Materials and Structures, 34, 5, 2001, 266-272
Google Scholar

Yeon J.H., Choi S., Won M.C.: In situ measurement of coefficient of thermal expansion in hardening concrete and its effect on thermal stress development. Construction and Building Materials, 38, 2013, 306-315
Google Scholar

Fu X., Chung D.D.L.: Effects of silica fume, latex, methylcellulose, and carbon fibers on the thermal conductivity and specific heat of cement paste. Cement and Concrete Research, 27, 12, 1997, 1799-1804
Google Scholar

Zhang D., Li Z., Zhou J., Wu K.: Development of thermal energy storage concrete. Cement and Concrete Research, 34, 6, 2004, 927-934
Google Scholar

Pomianowski M., Heiselberg P., Jensen R.L., Cheng R., Zhang Y.: A new experimental method to determine specific heat capacity of inhomogeneous concrete material with incorporated microencapsulated-PCM. Cement and Concrete Research, 55, 2014, 22-34
Google Scholar

Kodide U., Shin A.H.: Effects of thermal properties on temperature and moisture profiles, and the performance of PCC pavements. Journal of Engineering and Applied Sciences, 6, 12, 2011, 88-96
Google Scholar

Chung Y.: Thermal stress analysis of jointed plain concrete pavements containing fly ash and slag. PhD Thesis, Louisiana State University, 2012
Google Scholar

Nantung T.: High Performance Concrete Pavement in Indiana. Joint Transportation Research Program, SPR-2642, Report No. FHWA/IN/JTRP-2011/20, 2011
Google Scholar

Zhu B.: Thermal Stresses in Fixed Slab or Free Slab, in: Thermal Stresses and Temperature Control of Mass Concrete. Tsinghua University Press, 2014, 121-142
Google Scholar

Yehia S., Landolsi T., Hassan M., Hallal M.: Monitoring of strain induced by heat of hydration, cyclic and dynamic loads in concrete structures using fiber-optics sensors. Measurement, 52, 2014, 33-46
Google Scholar

Zou X., Chao A., Tian Y., Wu N., Zhang H., Yu T.Y., Wang X.: An experimental study on the concrete hydration process using Fabry-Perot fiber optic temperature sensors. Measurement, 45, 5, 2012, 1077-1082
Google Scholar

Linek M., Nita P.: Thermal effects on airfield surfaces. 9-th European conference of young research and scientific workers. University of Żilina, Slovak Republic, Transcom 2011, 7, 2011, 85-88
Google Scholar

Campbell-Allen D., Desai P.M.: The influence of aggregate on the behaviour of concrete at elevated temperatures. Nuclear Engineering and Design, 6, 1, 1967, 65-77
Google Scholar

Bier T.A., Wise S., Chang P.: A mechanistic study of failure of concrete subjected to cyclic thermal loads. Naval Civil Engineering Laboratory, CR 91.008, Port Hueneme, CA 93043, USA, 1991
Google Scholar

Sullivan P.J., Poucher M.P.: The influence of temperature on the physical properties of concrete and mortar in the range 20°C to 400°C. American Concrete Institute Special Publication, 25, 1971, 103-136
Google Scholar

Parth Panchmatia

ppanchma@purdue.edu

Affiliation:

Purdue University, School of Civil Engineering, West Lafayette, IN, USA

Michał A. Glinicki

Affiliation:

Institute of Fundamental Technological Research Polish Academy of Sciences, Warsaw

Bio Statement (e.g., department and rank)

Instytut Podstawowych Problemów Techniki Polskiej Akademii Nauk, Warszawa

Jan Olek

Affiliation:

Purdue University, School of Civil Engineering, West Lafayette, IN, USA

Influence of mixture composition on thermal properties of concrete and the performance of rigid pavement

Abstract

Keywords:

Similar Articles

Most read articles by the same author(s)

Downloads

Parth Panchmatia

Michał A. Glinicki

Jan Olek