Published: 2023-06-30

Influence of partial replacement of cement CEM I 42.5R by milled limestone on the propeties of cement pastes and mortars

Ewelina Tkaczewska

Abstract

Paper analyses the properties of cement pastes and mortars prepared with a mixture of Portland cement (PC) and milled limestone (ML) in the amount of 5%, 15%, 30%, 35%, 40% and 50% by weight. For cement pastes, the hydration heat, standard consistency and initial setting time were studied. For cement mortars, the compressive strength was determined. As the share of ML increases, the rate of hydration heat release decreases. Compared to control cement, cement with up to 35% ML shows similar initial setting time, while at the share of 40% and 50% ML the initial setting time is noticeably shortened. Cement containing 5% and 15% ML is in the strength class of 42.5R, while that with 30% and 35% ML is in the strength class of 32.5N. At 40% and 50% ML, cements do not meet the requirements of the PN-EN 197-1:2012 standard with respect to the strength class.

Keywords:

compressive strength, hydration heat, initial setting time, milled limestone, Portland cement, standard consistency.

Similar Articles

<< < 1 2 3 4 5 6 7 8 9 10 > >> 

You may also start an advanced similarity search for this article.

Download files

PDF (Język Polski)

Citation rules

Tkaczewska, E. (2023). Influence of partial replacement of cement CEM I 42.5R by milled limestone on the propeties of cement pastes and mortars. Roads and Bridges - Drogi I Mosty, 22(2), 119–139. https://doi.org/10.7409/rabdim.023.006

Cited by / Share


This website uses cookies for proper operation, in order to use the portal fully you must accept cookies.