Published: 2017-03-29

Comparison of rheological properties of chosen elastomers used in production of bridge bearings

Marcin Gajewski

Abstract

The paper presents the results of rheological testing performed with the use of DMA (Dynamic Mechanical Analyser) rheometer on specimens made of natural rubber (NR) and synthetic rubber (CR) elastomeric materials typically used for production of bridge bearings. The experiments provided the values of complex stiffness modulus and phase shift angles over a very wide temperature and frequency range, enabled determination of glass transition temperatures and plotting the master curves of the respective materials and, moreover, indentation tests were carried out with a spherical indenter pressed down with linearly increasing force. The test results can be used for both qualitative and quantitative evaluation of the materials and for determining certain mechanical parameters of linear viscoelastic constitutive models formulated for the infinitesimal strain theory. The indentation test was conducted to obtain values which can be used for indirect validation of constitutive hyperelastic and visco-hyperelastic models built up for continuum large deformation theory. Moreover, the paper partly evaluates the effect of long-term (natural) ageing of materials on their rheological properties.

Keywords:

ageing of elastomers, complex stiffness modulus, damping, DMA, elastomeric bridge bearings, glass transition temperature, rheological properties

Similar Articles

<< < 14 15 16 17 18 19 20 21 22 23 > >> 

You may also start an advanced similarity search for this article.

Most read articles by the same author(s)

Download files

PDF

Citation rules

Gajewski, M. (2017). Comparison of rheological properties of chosen elastomers used in production of bridge bearings. Roads and Bridges - Drogi I Mosty, 16(1), 47–64. https://doi.org/10.7409/rabdim.017.004

Cited by / Share


This website uses cookies for proper operation, in order to use the portal fully you must accept cookies.