Evaluation of the two methods of determining bulk density of sand: tapping fork test and vibrating table test

Waldemar St. Szajna; Paulina Lechocka

doi:10.7409/rabdim.016.001

Published: 2016-03-31

Vol. 15 No. 1 (2016)

Evaluation of the two methods of determining bulk density of sand: tapping fork test and vibrating table test

Waldemar St. Szajna , Paulina Lechocka

Section: Articles

https://doi.org/10.7409/rabdim.016.001

Abstract

The aim of this research is to compare and evaluate the methods used for determining the maximum bulk density of sand ρ_dmax. Two methods were considered: tapping fork test and vibrating table test. They were compared in terms of the efficiency of compaction and the repeatability of results. The tested material was quartz sand. The tapping fork test was carried out independently by two lab workers. While the tapping fork method proved to be satisfactory in terms of compaction efficiency (as demonstrated by the mean bulk density of ρ_dmax=1.805 g/cm³), it was not as good in terms of repeatability (3.35% of relative error) and showed sensitivity to human factor. The second test was performed using a vibrating table with inertial excitation. Selecting an appropriate frequency of vibrations proved to be a key factor. Too low frequency resulted in poor compaction and in case of too high frequency the density was increasing and decreasing alternately. The frequency of 39 Hz was found to be the optimum value, producing the average density of ρ_dmax=1.795 g/cm³ and 1.56% of relative error after vibrating for the standard time of 12 minutes. Even seemingly small variations of relative error between the analysed methods resulted in considerable variations in the degree of compaction of the tested sand. Therefore, the selection of the method is so important due to the criterion of test objectivity.

Keywords:

bulk density, tapping fork, test method efficiency and repeatability, vibrating table

Similar Articles

Mirosław Graczyk, Marcin Gajewski, Radosław Szczerba, Structural analysis of airfield concrete pavement with doweled joints taking into account curling of slabs , Roads and Bridges - Drogi i Mosty: Vol. 15 No. 2 (2016)
Bartłomiej Krawczyk, Antoni Szydło, Identification of homogeneous pavement sections , Roads and Bridges - Drogi i Mosty: Vol. 12 No. 3 (2013)
Damian Bęben, Experimental tests of railway culvert made from corrugated plates under service loads using interferometric radar , Roads and Bridges - Drogi i Mosty: Vol. 10 No. 1-2 (2011)
Robert Jurczak, Paweł Mieczkowski, Oliwia Merska, Maria Ratajczak, Effectiveness of a specific Reclaimed Asphalt Pavement (RAP) rejuvenating agent , Roads and Bridges - Drogi i Mosty: Vol. 22 No. 4 (2023)
Muhammad Kamran, Muhammad Tariq Khan, Diyar Khan, Mohd Rosli Mohd Hasan, Noman Khan, Mati Ullah, Experimental evaluation of hot mix asphalt using coal bottom ash as partial filler replacement , Roads and Bridges - Drogi i Mosty: Vol. 22 No. 2 (2023)
Juliusz Cieśla, Mirosław Biskup, Marian Skawiński, Experimental analysis of stiffness of pre-tensioned concrete bridge beams , Roads and Bridges - Drogi i Mosty: Vol. 8 No. 1 (2009)
Karol Brzeziński, Grzegorz Adamczewski, Paweł Tutka, The influence of cyclic loading on the static strength of cement-bound sand – qualitative analysis , Roads and Bridges - Drogi i Mosty: Vol. 16 No. 1 (2017)
Marcin Świtała, Wiesław Liszewski, Typology of city residents’ activity in terms of their mobility , Roads and Bridges - Drogi i Mosty: Vol. 21 No. 4 (2022)
Marta Wasilewska, Władysław Gardziejczyk, Paweł Gierasimiuk, Evaluation of skid resistance of exposed aggregate concrete pavement in the initial exploitation period , Roads and Bridges - Drogi i Mosty: Vol. 16 No. 4 (2017)
Jan Król, New method of analysis of polymer modified bitumen microstructure , Roads and Bridges - Drogi i Mosty: Vol. 7 No. 4 (2008)

<< < 6 7 8 9 10 11 12 13 14 15 > >>

You may also start an advanced similarity search for this article.

Download files

PDF

Citation rules

Szajna, W. S., & Lechocka, P. (2016). Evaluation of the two methods of determining bulk density of sand: tapping fork test and vibrating table test. Roads and Bridges - Drogi I Mosty, 15(1), 5–20. https://doi.org/10.7409/rabdim.016.001

Cited by / Share

References

ASTM Standards: D 4253 - 00 Standard test methods for maximum index density and unit weight of soils using a vibratory table
Google Scholar

PN-88/B-04481: Grunty budowlane. Badania próbek gruntu
Google Scholar

Pisarczyk S.: Grunty nasypowe. Właściwości geotechniczne i metody ich badania. Oficyna Wydawnicza Politechniki Warszawskiej, Warszawa, 2004
Google Scholar

Pisarczyk S.: Czynniki wpływające na wibracyjne zagęszczenie gruntów niespoistych. Inżynieria i Budownictwo, 8, 1996, 475-479
Google Scholar

Whitman R.V., Ortigosa P.: Densification of sand by vertical vibration. 4th Word Conference on Earthquake Engineering, Santiago, Chile, 1969, 29-37
Google Scholar

Dobry R., Whitman R.V.: Compaction of sand on a vertically vibrating table. ASTM STP523-EB.7744-1, Baltimore, USA, 1973, 156-170
Google Scholar

Brand E.W.: Some observations on the control of density by vibration. ASTM STP523-EB.7744-1, Baltimore, USA, 1973, 121-132
Google Scholar

Tokue T.: Characteristics and mechanism of vibratory densification of sand and role of acceleration. Soils and Foundations, 16, 3, 1976, 1-18
Google Scholar

Rothenburg L., Bathurst R.J.: Micromechanical features of granular assemblies with planar elliptical particles. Géotechnique, 42, 1, 1992, 79-95
Google Scholar

Santamarina J.C., Shin H.: Friction in Granular Media, in: Meso-scale Shear Physics in Earthquake and Landslide Mechanics. CRC Press, London, 2009, 157-188
Google Scholar

Szajna W.St., Kraiński A.: The influence of roundness of sand particles on macroscopic critical strength of soil medium. International Conference on Continuous Media with Microstructure, Publishing House of Poznań University of Technology, 2015, 73-74
Google Scholar

Waldemar St. Szajna

w.szajna@ib.uz.zgora.pl

Affiliation:

University of Zielona Góra, Faculty of Civil Engineering, Architecture and Environmental Engineering; Prof. Z. Szafran 1 str, 65-516 Zielona Góra

Paulina Lechocka

Affiliation:

University of Zielona Góra, Faculty of Civil Engineering, Architecture and Environmental Engineering; Prof. Z. Szafran 1 str, 65-516 Zielona Góra

Evaluation of the two methods of determining bulk density of sand: tapping fork test and vibrating table test

Abstract

Keywords:

Similar Articles

Downloads

Waldemar St. Szajna

Paulina Lechocka