Influence of the construction technology on the texture and roughness of concrete pavements

Piotr Mackiewicz; Antoni Szydło; Bartłomiej Krawczyk

doi:10.7409/rabdim.018.007

Published: 2018-06-30

Vol. 17 No. 2 (2018)

Influence of the construction technology on the texture and roughness of concrete pavements

Piotr Mackiewicz , Antoni Szydło , Bartłomiej Krawczyk

Section: Articles

https://doi.org/10.7409/rabdim.018.007

Abstract

The paper presents studies of different ways of finishing the top surface of concrete pavements. The authors carried out investigations on selected concrete pavement stretches of motorways and expressways in Poland and analysed the variation in roughness and texture depending on the type of pavement structure and base, the temperature, the type of surface finish and the in-service time. It has been found that the construction technology and the type of pavement structure have a bearing on roughness while the top surface finish technology has an effect on texture. The highest pavement smoothness values were measured on the jointless continuously reinforced pavements. It is shown that the texture index considerably depends on the pavement service time. No effect of temperature on the investigated parameters was observed.

Keywords:

concrete pavement, continuously reinforced (no joints) pavements, IRI, MPD, pavement roughness, texture.

Most read articles by the same author(s)

Bartłomiej Krawczyk, Piotr Mackiewicz, Impact of repetitive loading on subgrade parameters derived from light weight deflectometer test , Roads and Bridges - Drogi i Mosty: Vol. 14 No. 1 (2015)
Piotr Mackiewicz, Bartłomiej Krawczyk, Influence of loading time on subgrade parameters derived from VSS static plate test , Roads and Bridges - Drogi i Mosty: Vol. 14 No. 1 (2015)
Bartłomiej Krawczyk, Piotr Mackiewicz, Impact of reinforcement layer material and thickness on deflections measured in the static and dynamic plate load tests , Roads and Bridges - Drogi i Mosty: Vol. 15 No. 2 (2016)
Bartłomiej Krawczyk, Piotr Mackiewicz, Antoni Szydło, Influence analysis of counterweight type used in static plate test on identified parameters of pavement courses and subgrade , Roads and Bridges - Drogi i Mosty: Vol. 14 No. 2 (2015)
Bartłomiej Krawczyk, Antoni Szydło, Piotr Mackiewicz, Dariusz Dobrucki, Assessment criteria of the recycled aggregate cement bound bases , Roads and Bridges - Drogi i Mosty: Vol. 18 No. 2 (2019)
Bartłomiej Krawczyk, Antoni Szydło, Identification of homogeneous pavement sections , Roads and Bridges - Drogi i Mosty: Vol. 12 No. 3 (2013)
Bartłomiej Krawczyk, Antoni Szydło, Piotr Mackiewicz, Dariusz Dobrucki, Suitability of aggregate recycled from concrete pavements for layers made of unbound and cement bound mixtures , Roads and Bridges - Drogi i Mosty: Vol. 17 No. 1 (2018)
Antoni Szydło, Piotr Mackiewicz, Determination of deflections of an innovative pavement structure containing a three-component hydraulic binder , Roads and Bridges - Drogi i Mosty: Vol. 22 No. 1 (2023)
Maciej Kruszyna, Antoni Szydło, Modelling of urban transport traffic flow on the separated lane between the junctions , Roads and Bridges - Drogi i Mosty: Vol. 2 No. 1 (2003)
Bartłomiej Krawczyk, Piotr Mackiewicz, Dariusz Dobrucki, Use of plastic waste in cement-bound layers , Roads and Bridges - Drogi i Mosty: Vol. 22 No. 3 (2023)

1 2 > >>

Download files

PDF

Citation rules

Mackiewicz, P., Szydło, A., & Krawczyk, B. (2018). Influence of the construction technology on the texture and roughness of concrete pavements. Roads and Bridges - Drogi I Mosty, 17(2), 111–126. https://doi.org/10.7409/rabdim.018.007

Cited by / Share

References

Farnsworth E., Johnson M.: Reduction of Wet Pavement Accidents on Los Angeles Metropolitan Freeways, SAE Technical Paper 710574, 1971
Google Scholar

Hibbs O., Larson R.: Tire Pavement Noise and Safety Performance. PCC Surface Texture Technical Working Group, FHWA-SA-96-068, May, 1996
Google Scholar

Noise and Texture on PCC Pavements - Results of a Multi-State Study. Report Number WI/SPR-08-99, Wisconsin Department of Transportation, June, 2000
Google Scholar

Scofield L.: Transportation Noise and Concrete Pavements, Using Quiet Concrete Pavements as the Noise Solution, ACPA, 2009
Google Scholar

Development and Implementation of the Next Generation Concrete Surface, IGGA, ACPA, Report, 2016
Google Scholar

Cable J.K., Wiegand P.: Surface Characteristics Next Generation Grooving and Grinding Iowa Test Site Construction, Final Report, National Concrete Pavement Technology Center, September, 2010
Google Scholar

Anderson K., Sexton T., Uhlmeyer J., Russell M., Weston J.: Concrete Pavement Noise, WA-RD 814.1, WSDOT Research Report, July, 2013
Google Scholar

Harvey J.T., Kohler E.: Quieter Pavement Research: Concrete Pavement Tire Noise, Research Report: UCPRC-RR-2010-03, May, 2011
Google Scholar

Cackler E.T., et. al.: Concrete Pavement Surface Characteristics: Evaluation of Current Methods for Controlling Tire-Pavement Noise, Final Report of FHWA Cooperative Agreement DTFH61-01-X-00042, Project 15, 2006
Google Scholar

Ferragut T., Rasmussen R.O., Wiegand P., Mun E., Cackler E.T.: ISU-FHWA-ACPA Concrete Pavement Surface Characteristics Program Part 2: Preliminary Field Data Collection, National Concrete Pavement Technology Center Report DTFH61-01-X-00042 (Project 15, Part 2), 2007
Google Scholar

Rasmussen R., Sohaney R., Fick G., Cackler E.T.: How to Design and Construct Quieter Concrete Pavements. 10International Conference on Concrete Pavements, July 8-12, 2012, Quebec
Google Scholar

Herman L., McAvoy D., Richardson W.: Effectiveness of Noise Barriers Installed Adjacent to Transverse Grooved Concrete Pavements. Federal Highway Administration, Job Number 134365, October 16, 2009
Google Scholar

Pitre J.G.: Improving the sound absorbing capacity of portland cement concrete pavements using recycled materials. Thesis, Bachelor of Science, University of New Hampshire, 2000
Google Scholar

American Concrete Pavement Association, Concrete Paving Technology: Constructing Smooth Concrete Pavements, Report RB006P, 2003
Google Scholar

Grogg M.G., Smith K.D.: PCC Pavement Smoothness: Characteristics and Best Practices for Construction, Report FHWA-IF-02-025, October, 2001
Google Scholar

Guntert & Zimmerman Const. Div., Inc.: Various Engineering Drawings, 4/20/2008.30. Minnesota Department of Transportation, Minnesota’s Astro-Turf Drag Technique Texturing Concrete Pavements, 2008
Google Scholar

Surface Texture for Asphalt and Concrete Pavements. Federal Highway Administration, Technical Advisory T 5040.36, 17 June, 2005
Google Scholar

ASTM International, Standard Test Method for Measuring Pavement Macrotexture Depth using a Volumetric Technique, Specification E965-96, 2001
Google Scholar

ASTM E 2157-02 Standard method for determining Mean Profile Depth using the Circular Track Meter. www.astm.org. Assessed 5/30/2009
Google Scholar

Karamihas S.M., Gillespie T.D., Perera R.W., Kohn S.D.: Diurnal changes in profile of eleven jointed PCC pavement. Proceedings of The 7International Conference on Concrete Pavements, Orlando, FL., 2001
Google Scholar

Hall J.W., Smith K.L.: Littleton Texturing of Concrete Pavements, NCHRP report 634
Google Scholar

Gardziejczyk W.: Texture of road surfaces - methods of measurement, parameters evaluation and its influence on the tire/road noise. Roads and Bridges - Drogi i Mosty, 1, 2, 2002, 5-29
Google Scholar

McNerney M.T., et al.: Comparative Field Measurements of Tire Pavement Noise of Selected Texas Pavement, Center of Transportation Research: Austin, TX, 1997
Google Scholar

Graf R.A.G., et al.: Horn Amplification at a Tyre/Road Interface - Part I: Experiment and Computation, Internoise: Fort Lauderdale, FL, 1999
Google Scholar

Sandberg U., Ejsmont J.A.: Influence of tyre rubber hardness on tyre/road noise emission. 36International Congress and Exhibition on Noise Control Engineering, Turkish Acoustical Society INTER-NOISE, 2007, Istambul, 1, 394-403
Google Scholar

Ejsmont J.A., Ronowski G., Świeczko-Żurek B., Sommer S.: Road texture influence on tyre rolling resistance. Road Materials and Pavement Design, 18, 1, 2017, 181-198
Google Scholar

Taryma S., Ejsmont J.A., Ronowski G., Świeczko-Żurek B., Mioduszewski P., Drywa M., Woźniak R.: Road texture influence on tire rolling resistance. Key Engineering Materials, 597, 2014, 193-198
Google Scholar

Ejsmont J., Taryma S., Ronowski G., Świeczko-Żurek B.: Influence of temperature on the tyre rolling resistance. International Journal of Automotive Technology, 19, 1, 2018, 45-54
Google Scholar

Wasilewska M., Gardziejczyk W.: Analiza ilościowa i jakościowa zmian mikroteksturalnych powierzchni kruszywa stosowanego do warstwy ścieralnej. Zeszyty Naukowe Politechniki Rzeszowskiej. Budownictwo i Inżynieria Środowiska, 59, 3/IV, 2012, 361-368
Google Scholar

Wasilewska M.: Polishing resistance of aggregates in aspect of its usage to wearing course road pavements. Prace Naukowe Instytutu Gornictwa Politechniki Wroclawskiej, 134, 2012, 301-310
Google Scholar

Wasilewska M., Gardziejczyk W., Gierasimiuk P.: Evaluation of skid resistance of exposed aggregate concrete pavement in the initial exploitation period. Roads and Bridges - Drogi i Mosty, 16, 4, 2017, 295-308
Google Scholar

Gardziejczyk W., Wasilewska M.: Evaluation of microtexture changes of coarse aggregate during simulated polishing. Archives of Civil Engineering, 62, 2, 2016, 19-34
Google Scholar

Cackler E.T.: Evaluation of U.S. and European Concrete Pavement Noise Reduction Methods. National Concrete Pavement Technology Center, Part 1, Task 2, of the ISU-FHWA, July, 2006
Google Scholar

Sommer H.: Optimierung der Lärmmindernden Waschbeton-oberfläche (Optimisation of Noise Reducing Exposed Aggregate Concrete Surfaces), Vienna (Austria): State Ministry for Economic Affairs, File 447, 1995
Google Scholar

Kowalski K.J., Bańkowski W., Król J.B., Gajewski M., Horodecka R., Świeżewski P.: Selection of quiet pavement technology for Polish climate conditions on the example of CiDRO project. Transportation Research Procedia, 14, 2016, 2724-2733
Google Scholar

Gardziejczyk W.: „Cicha” nawierzchnia drogowa jako sposób na ograniczenie poziomu hałasu od ruchu samochodowego. Inżynieria Ekologiczna, 40, 2014, 65-73
Google Scholar

Mioduszewski P.: Przegląd hałaśliwości nawierzchni drogowych w Polsce i w innych krajach Unii Europejskiej. Metody ochrony przed hałasem. Teoria i praktyka, 1, 2013, 159-173
Google Scholar

Gardziejczyk W., Gierasimiuk P.: Influence of texturing method on tyre/road noise of cement concrete pavement. International Journal of Pavement Engineering, 2016, 1-16 (Article in Press)
Google Scholar

ASTM E 1926 - 08 Standard Practice for Computing International Roughness Index of Roads from Longitudinal Profile Measurements
Google Scholar

PN-EN ISO 13473-1:2005E Charakterystyka struktury nawierzchni przy użyciu profili powierzchniowych
Google Scholar

Rozporządzenia Ministra Infrastruktury z dnia 16 stycznia 2002 r. w sprawie przepisów techniczno-budowlanych dotyczących autostrad płatnych. Część 1: Określenie średniego profilu głębokości
Google Scholar

Diagnostyka stanu nawierzchni i jej elementów. Wytyczne stosowania. GDDKiA, Warszawa, kwiecień 2015 r.
Google Scholar

Piotr Mackiewicz

piotr.mackiewicz@pwr.edu.pl

Affiliation:

Wrocław University of Science and Technology, Faculty of Civil Engineering, 41 Wybrzeże Stanisława Wyspiańskiego Street, 50-370 Wrocław

Antoni Szydło

Affiliation:

Wrocław University of Science and Technology, Faculty of Civil Engineering, 41 Wybrzeże Stanisława Wyspiańskiego Street, 50-370 Wrocław

Bartłomiej Krawczyk

Affiliation:

Wrocław University of Science and Technology, Faculty of Civil Engineering, 41 Wybrzeże Stanisława Wyspiańskiego Street, 50-370 Wrocław

Influence of the construction technology on the texture and roughness of concrete pavements

Abstract

Keywords:

Similar Articles

Most read articles by the same author(s)

Downloads

Piotr Mackiewicz

Antoni Szydło

Bartłomiej Krawczyk